[highlight]THIS CLASS IS FULL[/highlight]
One Day seminar on Flygt equipment geared towards Pump Repair and Maintenance.
December 3, 2019 – Pewaukee – Flygt Office, N27 W23291 Roundy Dr. Pewaukee WI, 53027 Limit 20
January 22, 2020 – Fox Lake – Community Center, 248 E State St. Fox Lake, WI, 53933
February 6, 2020 – Chetek – City Hall, 220 Stout St. Chetek, WI 54728
The purpose of this course is to acquaint the attendee with the construction, operation and maintenance of submersible pumps in general and Flygt pumps in particular. Course lecture will include Power Point presentations, videos and hands-on activities. The class at Pewaukee will start at 8:00am in the morning and end at 3:00pm. The class at Fox Lake will start at 7:30 and end at 2:30pm. Classroom presentations and videos and in the afternoon will consist of bench/shop activities including the disassembly and re-assembly of a pump.
Water/Wastewater/Engineering Credits for Attendees
- Book used during all classroom lectures will be Flygt’s “Product Education Manual” and can be taken with the attendee at the end of the seminar.
- Dress will be casual. The handling of some equipment may be dirty.
- Class size is limited to 20 people when offered at a Flygt facility.
8:00 AM – 10:00 AM (Pewaukee)
7:30 AM – 9:30 AM (Fox Lake Chetek)
Introduction/Mechanical – Flygt Pumps (PowerPoint Presentation)
A. Introduction to a Submersible pump
B. Junction Chamber
C. Terminal Board
D. Stator/Cable Connections
E. Cable Entry
10:00 AM – 12:00 AM (Pewaukee)
9:30 AM – 11:30 AM (Fox Lake & Chetek)
Motor/Stator/Dry motor Compartments (PowerPoint Presentation, Video)
A. Pump Rotation
B. Nameplate Data
C. Motor Housing Overview
D. Stator (winding, insulation)
E. Thermal Switches/Thermal Sensors
F. Leak Detectors
G. Monitor and Control Modules
H. Motor Maintenance
I. Stators (removal, installation)
J. Bearings (removal, installation, lubrication)
K. Shafts/Rotors (removal, installation)
L. Special Tools
M. Introduction to Cooling Systems
12:00 AM – 1:00 PM Lunch (Pewaukee)
11:30 AM – 12:30 PM Lunch (Fox Lake & Chetek)
Tear Down and Re-assemble a 5 and 10 HP pumps.
PRE-REGISTRATION REQUIRED (NO FEE)